Any Latest version available for S3400N connector?
Is there any possibility for Auto transfer of the SEM data to the Image-Pro
software, if there is any latest version available for S3400N connector.
0
Answers
-
If there is a Capture Interface for your specific camera model, you can acquire images directly into the Image-Pro environment. Supported Capture Interfaces can be found here: https://www.mediacy.com/support/hardware.
Best Regards,
Scott Reed0 -
2021-07-26-183723BrijeshwarIf the S3400N that you are referring to is aHitachi S-3400Nthen if that device can save its images in a LOCATION / FOLDER that IMAGE-PRO can access, then if they are one of IMAGE FILE TYPES that IMAGE-PRO can open,Here are two SCREEN GRABS from the IMAGE FILE OPEN to show a list of the IMAGE FILES that IMAGE-PRO will OPEN.I hope this information is helpful.-- Matt
0
Categories
- All Categories
- 961 Image-Pro v9 and higher
- 9 Image-Pro FAQs
- 18 Image-Pro Download & Install
- 448 Image-Pro General Discussions
- 486 Image-Pro Automation (Macros, Apps, Reports)
- 20 AutoQuant Deconvolution
- 2 AutoQuant Download & Install
- 18 AutoQuant General Discussions
- 195 Image-Pro Plus v7 and lower
- 3 Image-Pro Plus Download & Install
- 106 Image-Pro Plus General Discussions
- 86 Image-Pro Plus Automation with Macros
- 19 Legacy Products
- 16 Image-Pro Premier 3D General Discussions
- 26 Image-Pro Insight General Discussions