DOWNLOAD IMAGE-PRO EXPRESS 4.5.1.3
HI GUYS GOOD MORNING
I NEED THE INSTALLER OF IMAGE-PRO EXPRESS 4.5.3.
0
Answers
-
Dear Sir/Madam:
I purchased and installed IMAGE-PRO EXPRESS quite a few years ago (ca 2003) and has used the program with images obtained from my HITACHI electronic scanning microscope but then did not used it for about 3 years. Recently, I tried to use the device and program again, but found that my hard drive (in which the programs and associated driver were loaded) crushed. Then I use another PC (OS is WindowXP) and installed the IMAGE_PRO EXPRESS from the original CDs but could not resume the utility. My Serial Number is 58N50000-6645.
I am wondering if I missed (or do not have) some drivers that can operate the graphic capture card (IT 540768). Would you please advise me how to get a proper driver by downloading? or are there other ways to recover the capacity on a new computer?
Sincerely yours,
Kuo-Yen Wei
Professor, Dept. of Geosciences, National Taiwan University.0 -
Dear Kuo-Yen,
Please send email to techsupp@mediacy.com, they should be able to help you.
Regards,
Yuri
0
Categories
- All Categories
- 961 Image-Pro v9 and higher
- 9 Image-Pro FAQs
- 18 Image-Pro Download & Install
- 448 Image-Pro General Discussions
- 486 Image-Pro Automation (Macros, Apps, Reports)
- 20 AutoQuant Deconvolution
- 2 AutoQuant Download & Install
- 18 AutoQuant General Discussions
- 195 Image-Pro Plus v7 and lower
- 3 Image-Pro Plus Download & Install
- 106 Image-Pro Plus General Discussions
- 86 Image-Pro Plus Automation with Macros
- 19 Legacy Products
- 16 Image-Pro Premier 3D General Discussions
- 26 Image-Pro Insight General Discussions