Scale bar on oif or oib composite file
Hi,
Is it normal that when I open a multi channel file from a Olympus microscope, I can't put a scale bar on the composite view. I have to switch from the composite view to a single channel view for the scale bar to show.
Thank you,
0
Comments
-
2017-11-10-104321
JPCLAMME --
I only have one OIF FILE to work with and it is from 2016.
It opens with PREMIER 3D V9.3 but none of the CALIBRATION ROUTINES seem to like that IMAGE FILE.
If the TECH SUPPORT DEPT at MEDIA CY need OIF FILES to work with to investigate this issue, perhaps you and I can be a source of a couple of examples.
I hope this information is helpful.
-- MATT
0 -
In my case it finds the calibration values but just does not want to display the bar in composite view mode.
0 -
You can show calibration marker on composite view using Data Overlay: View tab, Data Overlay group, activate Show and Marker.
Yuri
0
Categories
- All Categories
- 961 Image-Pro v9 and higher
- 9 Image-Pro FAQs
- 18 Image-Pro Download & Install
- 448 Image-Pro General Discussions
- 486 Image-Pro Automation (Macros, Apps, Reports)
- 20 AutoQuant Deconvolution
- 2 AutoQuant Download & Install
- 18 AutoQuant General Discussions
- 195 Image-Pro Plus v7 and lower
- 3 Image-Pro Plus Download & Install
- 106 Image-Pro Plus General Discussions
- 86 Image-Pro Plus Automation with Macros
- 19 Legacy Products
- 16 Image-Pro Premier 3D General Discussions
- 26 Image-Pro Insight General Discussions